Hyundai Genesis: General Information / Specifications

Specifications
Purge Control Solenoid Valve (PCSV)
? Specification
Item
Specification
Coil Resistance (?)
22.0 ~ 26.0 [20°C(68°F)]

Fuel Tank Pressure Sensor (FTPS)
? Type: Piezo-Resistive Pressure Sensor
? Specification
Pressure [kPa (kgf/cm?, psi)]
Output Voltage (V)
-6.67 (-0.06, -0.97)
0.5
0
2.5
+6.67 (0.068, 0.97)
4.5

Canister Close Valve (CCV)
? Specification
Item
Specification
Coil Resistance (?)
23.0 ~ 26.0 [20°C(68°F)]

Tightening Torques
Item
kgf.m
N.m
lb-ft
Positive Crankcase Ventilation (PCV) Valve installation
0.8 ~ 1.2
7.8 ~ 11.8
5.8 ~ 8.7
Canister installation bolt
2.0 ~ 3.0
19.6 ~ 29.4
14.5 ~ 21.7
Canister band installation nut
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Vacuum hose connector assembly installation bolts
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Fuel tank pressure sensor installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Canister close valve installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3

Description and Operation
Description Emissions control system consists of the three major systems. • Crankcase Emission Control System prevents blow-by gas from going into the atmosphere. This system burns this gas ...

Troubleshooting
Troubleshooting SymptomSuspect AreaEngine does not start or is hard to startVapor hose damaged or disconnectedEEngine struggles to startMalfunction of the purge control solenoid valveRough idle o ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: External AMP Components and Components Location


Components NO.Connector ANO.Connector BNO.Connector C1B (+)1-1Right side low (+)2B (+)2-2Left side low (+)3B (+)3-3Right front midrange/tweeter (+)4-4-4Left front midrange/tweeter (+)5Multimedia-CAN (high)5-5Right front door (+)6Multimedia-CAN (low)6-6Left front door (+)7ACC7-7Right side low (- ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Idler Repair procedures


Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the drive belt idler (A). Tightening torque : 44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft) 3. To install, reverse the removal procedure. Inspection Drive belt, Idler, ...

© 2013-2024 www.hgenesisdh.com