Hyundai Genesis (DH): Automatic Transmission Control System / Shift Lever Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Shift Lever Repair procedures

Removal
1.
Remove the console upper cover (A).
2.
Pull the shift lever knob (B) upward to remove it.

3.
Remove the knob&boots(A) from the console upper cover.

4.
Remove the floor console.
(Refer to Body - "Floor Console")
5.
Disconnect the connector (A) from the shift lever.

6.
Disconnect the shift cable (A) from the shift lever.

7.
Remove the shift lever assembly (A) by removing the four bolts.
Tightening torque :
9 ~ 14 N.m (0.9 ~ 1.4 kgf.m, 6.51 ~ 10.12 lb-ft)

Installation
1.
To install, reverse the removal procedure.

    Components 1. Shift lever knob2. Shift lever boots3. Shift lever assembly4. Shift cable

    Components 1. Shift lever knob2. Shift lever boots3. Shift lever assembly4. Shift cable

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.

    Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Description and Operation

    Description An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the cabin. The signal determined by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signa

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0209