Hyundai Genesis: Body Side Molding / Rear Mud Guard Repair procedures

Replacement

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface.

1.	After loosening the mounting screw, remove the rear mud guard (A) by using a screw driver.

2.	Install in the reverse order of removal. • Replace any damaged clips.

Front Mud Guard Repair procedures

Replacement     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scra ...

Waist Line Molding Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: Outside Temperature Gauge

This gauge indicates the current outside air temperatures by 1°F (1°C). - Temperature range : -40°F ~ 140°F (-40°C ~ 60°C) The outside temperature on the display may not change immediately like a general thermometer to prevent the driver from being inattentive. The temperature u ...

Hyundai Genesis (DH) 2013-2016 Service Manual: AWD ECU Repair procedures

Removal 1. IG Key "ON". 2. Connect the GDS in the vehicle. 3. To read the transfer case data in old ITA(ECU), select "ECU Data Back-up & Writing" service of GDS. 4. IG key "OFF". 5. Remove the under cover. (Refer to Engine mechanical system - "Engine room under cover") ...