Hyundai Genesis: Rear Suspension System / Rear Lower Arm Repair procedures
1. |
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. |
2. |
Remove the front wheel and tire (A) from the rear hub.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
|

Be careful not to damage the hub bolts when removing the rear wheel and tire. |
|
3. |
Disconnect the rear stabilizer link & height sensor (B) from the rear lower arm by loosening the nut (A).
Tightening torque:
Height sensor : 3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
Stabilizer link :98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)
|


|
4. |
Loosen the mounting bolt & nut (A, B) and then remove the rear lower arm.
Tightening torque :
(A) 107.9 ~ 117.7N.m (11.0 ~ 12.0kgf.m, 79.6 ~ 86.8lb-ft)
(B) 137.2 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
|

|
5. |
Installation in the reverse order of removal. |
6. |
Check the alignment.
(Refer to Tires/Wheels - "Alignment") |
1. |
Check the bushing for wear and deterioration. |
2. |
Check the rear lower arm for deformation. |
4. |
Check the coil spring pad for deterioration and deformation. |
Removal
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the rear hub.
Tightening torque:
88.3 ~ 10 ...
Removal
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the rear hub.
Tightening torque:
88.3 ~ 10 ...
Other information:
Applying the parking brake
To apply the EPB (Electric Parking
Brake):
1.Depress the brake pedal.
2.Pull up the EPB switch.
Make sure the Parking Brake
Warning Light comes on.
Also, the EPB is applied automatically
if the [AUTO HOLD] switch is on
when the engine is turned off.
Howeve ...
Component Location
1. Trunk lid trim
...