| Components |

| 1. Radiator assembly 2. Radiator upper mounting bracket 3. Radiator lower mounting insulator 4. Radiator cap | 5. Radiator lower hose 6. Radiator upper hose 7. Clamp |
Troubleshooting SymptomsRemedyIf the cooling fan is not functioning under normal operating conditions
Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Loosen the drain plug and drain the engine coolant. (Refer to Cooling System - "Coolant") 3.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor. (Refer to Windshield Wiper/Washer - "Rain Sensor") Installation 1. Install the auto light sensor. 2. Connect the negative (-) battery terminal.
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.