Hyundai Genesis: Power Trunk Module / Power Trunk Inner Switch Repair procedures

Inspection

1.	Remove the trunk inner switch.

2.	Check for continuity between terminals of the trunk inner switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the left trunk trim after opening the trunk. (Refer to Body - "Trunk Trim")

3.	Remove the trunk inner switch (A) after disconnecting the connector.

Installation

1.	Install the power trunk inner switch after connecting the connector and mounting bolts.

2.	Install the trunk trim.

3.	Check that the power trunk module operates normally after connecting the negative (-) battery terminal.

Power Trunk Inner Switch Components and Components Location

Component ...

Power Trunk Open/Close Switch Components and Components Location

Components ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: CVVT Oil Temperature Sensor (OTS) Description and Operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which m ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Trunk fuse panel (Rear fuse box panel)

Inside the fuse/relay box covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable to your vehicle. It is accurate at the time of printing. When you inspect the fuse box on your vehi ...