Hyundai Genesis (DH): Automatic Transmission Control System / Input Speed Sensor Specifications
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Input Speed Sensor Specifications
| Specifications |
? Type: Hall Effect Sensor
? Specifications
| Operation condition ( |
Description Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transmission and delivers the readings to the TCM.
Circuit Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).
Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- General Information
- Steering System
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0383