Hyundai Genesis (DH): Automatic Transmission Control System / Input Speed Sensor Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Input Speed Sensor Description and Operation
| Description |
Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transmission and delivers the
readings to the TCM. The sensor provides critical input data that's used
in feedback control, damper clutch control, gear setting control, line
pressure control, clutch activation pressure control, and sensor fault
analysis.
Inspection 1. Check signal waveform of output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section.
Specifications ? Type: Hall Effect Sensor ? Specifications Operation condition (
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Power Mosfet Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and control the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)13.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Heating, Ventilation and Air Conditioning
- Smart Cruise Control Unit Repair procedures
- Brake System
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0428