Hyundai Genesis (DH): General Information / Troubleshooting

Hyundai Genesis (DH) 2013-2016 Service Manual / Driveshaft and axle / General Information / Troubleshooting

Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel bearing
Replace
Defective front suspension and steering
Adjustment or Replace
Vibration
Wear, damage or bending of driveshaft
Replace
Driveshaft rattle and hub serration
Replace
Wear, rattle or scratching of wheel bearing
Replace
Shimmy
Defective wheel balance
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace
Excessive noise
Wear, damage or bending of driveshaft
Replace
Rattle of driveshaft and worn hub splines
Replace
Wear, rattle or scoring of wheel bearing
Replace
Loose hub nut
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace

    Special Service Tools Tool Name / NumberIllustrationDescriptionBall joint remover09581-11000Spreading the front disc brake piston.Ball joint remover09568-2J100Removal of the rear assist arm and tie rod end ball joint.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures

    Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0328