Hyundai Genesis (DH): Heater / Temperature Control Actuator Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Temperature Control Actuator Description and Operation

Description
The temperature control actuator is located in the heater unit. It regulates the temperature according to the procedures as follows.
The temperature control actuator is operated by the temperature switch and adjusts the position of the temperature door to regulate discharge temperature.

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine cools down, drain the engine coolant from the radiator.

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Components and Components Location

    Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0206