Hyundai Genesis (DH): Heater / Temperature Control Actuator Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool (Driver's side) or warm (Passenger's side) position when connected in reverse.

1. -
2. -
3. Warm position
4. Cool position
5. Sensor (+ 5V)
6. Feedback signal
7. Sensor ground

4.
Connect the temperature control actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminal 6 and 7 (between terminal 5 and 6 for passenger

    Description The temperature control actuator is located in the heater unit. It regulates the temperature according to the procedures as follows.

    Description The mode control actuator is located in the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0277