| Specification |
| Item | Specification |
| Power source | 3V |
| Operating temperature | -30 |
Component Location 1. Burglar horn2. BCM3. Door lock / unlock buzzer4. Front door lock actuator & switch5. Rear door lock actuator &switch6.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.