Hyundai Genesis (DH): BCM (Body Control Module) / Schematic Diagrams

Circuit Diagram

    Components NOConnector AConnector  BConnector  C1Battery +-Room lamp Output2IGN1ECM Mirror +Foot lamp Output3IGN2B CAN High-4ACCB CAN Low-5-PAS (LIN)-6-Integrated sensor (LIN)L_Head lamp washer RLY_OUT7Rear Window Defroster switch-External buzzer output8parking brake switch-SSB light output9PAS off switch-Mood lamp output10Rear curtain switch-Rear curtain motor down Output11sunroof state-Rear curtain motor UP Output12--ATM Solenoid outputs13Trunk open switch-Rear Seat belt light output(RH)14L_NADRI_OPT_INRear Seat belt light output(LH)Rear defogger  light output 15L_Deolicated DRI_OPT_INRear Seat belt light output(Center)PAS on  light output 16-GND (Power)safety belt light output (Assist)17-?   security light output 18-?-19-?-20-?-21-?GND (Rear curtain motor)22-?Rear curtain Power23-??24-??25-??26GND??

    Description Body Control Module (BCM) function NOBCM Function1Burglar Alarm2Defroster3Rear Curtain4ATM control5Tail Lamp6H/Lamp Low/High7Welcom/Escort8Auto Light9Passing 10HBA11Front/Rear Fog Lamp12AV Tail13DRL lamp control14Static Bending15Flasher16Room Lamp 17Foot Lamp18Mood Lamp19SSB Ring Illumination2021Panic Alarm22Remote Start23Trunk24SBR25Key Operated Warning26Parking Brake Warning27SMK System Warning28Sun Roof Open Warning29PAS Warning30Front Wiper Low/High31Front Wiper Mist 32Front Wiper Auto33Front Wiper Washer34USM35ECM Mirror36CAN 37LIN Communication Network Diagram AbbreviationExplanationAAFActive Air FlapACUAirbag Control UnitADMAssist Door ModuleAHDActive Hood SystemAMPAmplifierARSArmrest SwitchASCCAdvanced Smart Cruise ControlAVMAround View MonitorAWDAll Wheel DriveB_CANBody Controller Area NetworkBCMBody Control ModuleBSDBlind Spot DetectionC_CANChassis Controller Area NetworkCCPCenter Control PanelCLUMCluster ModuleDATCDual Automatic Temp ControlDDMDriver Door ModuleDisplayDisplay MonitorDSSDriver Seat SwitchECSElectronic Control SuspentionEMSEngine Management SystemEPBElectronic Parking BrakeEVPEva Vacuum PumpFPCMFuel Pump Control ModuleH/UnitHead UnitHSWSHaptic Steering Warning SystemHUDHead Up DisplayI-BOXTelematics SystemIDBIntegrated Dynamic BrakeLDWSLane Departure Warning SystemM_CANMulti media Controller Area NetworkMDPSMotor Driven Power SteeringMFSMulti-Function SwitchODSOccupant Detection SystemP_CANPowertrain Controller Area NetworkPGSParking Guide SystemPSBPre-Safe Seat BeltPSMPower Seat ModulePTLMPower Trunk Lid ModuleRRCRear Remote ControlSASSteering Angle SensorSCMSteering Column ModuleSJBSmart Junction BoxSLBSeat Lumber BolsterSMKSmart Key UnitSPASSmart Parking Assist SystemSWRCSteering Wheel Remote ControllerTCUTransmission Control UnitTPMSTire Pressure Monitoring SystemVDCVehicle Dynamic Control

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Specifications

    S

    Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.

    Categories

     
    Copyright © 2025 www.hgenesisdh.com - 0.0165