Hyundai Genesis (DH): Cooling System / Reservoir Tank Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Cooling System / Reservoir Tank Repair procedures

Removal and Installation
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the engine cover.
3.
Remove the engine room cover.
(Refer to Engine And Transaxle Assembly - "Engine Cover")
4.
Remove the reservoir tank (A) after loosening the mounting bolts from cooling fan. and then disconnect the over flow hose (B).
Tightening torque :
4.9 ~ 8.3 N.m (0.50 ~ 0.85 kgf.m, 3.6 ~ 6.1 lb-ft)

5.
To install, reverse the removal procedure.

    Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Loosen the drain plug and drain the engine coolant. (Refer to Cooling System - "Coolant") 3.

    Components 1. Water temperature control assembly2. O-ring3. Water outlet pipe4. Water center pipe5. Water inlet pipe

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures

    Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0282