Hyundai Genesis (DH): Panorama Sunroof / Repair procedures

Adjustment
Inspect Glass Alignment
1.
Check the alignment of the movable glass (C) located between the front (A) and rear (B) glass and adjust it if necessary.

Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Completely open the movable glass using the panorama sunroof switch.
3.
Separate both decoration covers (A) and then remove the folding cover (B).

4.
By pushing the panorama sunroof switch, fully close the movable glass.
5.
Adjust the height of the glass by slightly loosening the screws (A).
   

    Components 1. Roller blind bracket2. Roller blind 3. Mechanism rail assembly4. Motor5. Panorama sunroof frame assembly6. Front glass7. Roof side moulding8.

    Replacement 1. By pushing the panorama sunroof switch, fully open the movable glass. 2. Separate both decoration covers (A) and then remove the folding cover (B).

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: License Lamps Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Back Panel") 3. Remove the license lamp after disengaging the license lamp mounting clip (A) 4. Remove the license lamp assembly after disconnecting the license connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.029