Hyundai Genesis (DH): Cylinder Block / Rear Oil Seal Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal
1.
Remove the drive plate and adapter plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).

Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil seal.

   
Always use a new oil seal.
2.
Install the drive plate and adapter plate.
(Refer to Cylinder Block - "Drive Plate")

    Components 1. Rear oil seal2. Rear oil seal case

    Components 1. Piston ring2. Piston pin3. Snap ring4. Piston5. Connecting rod6. Connecting rod upper bearing7. Connecting rod lower bearing8. Connecting rod bearing cap

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Console Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0352