Hyundai Genesis (DH): Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Description and Operation

Description
According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's vision from glare, aiming at safety driving.
Sensor integrated ECU mounting on the rear center arm drives the actuator mounting on the head lamp since sensing the input signal following the vehicle's statically changes.
Head lamp beam is automatically operated by chassis tilt.
Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Sensor angle change.
3.
Microprocessor calculates necessary head lamp angle change amount.
4.
Sending a proper signal to head lamp leveling device and driving actuator.
Operating Condition
1.
Ignition on
2.
Low beam on
3.
On stop : If sensor lever change is 0.3

    Circuit Diagram

    Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Start/Stop Button Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the start/stop button (A) from the center fascia garnish after loosening the mounting clip.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and control the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)13.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0214