Hyundai Genesis (DH): Engine Control System / Rail Pressure Sensor (RPS) Specifications

Specification

    Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal.

    Signal Waveform

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Repair procedures

    Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.03