Hyundai Genesis (DH): Lubrication System / Oil Level Gauge & Pipe Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Lubrication System / Oil Level Gauge & Pipe Repair procedures

Removal and Installation
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the engine room cover and the radiator grill upper cover.
(Refer to Engine And Transaxle Assembly - "Engine Cover")
4.
Remove the oil level gauge.
5.
Remove the water outlet pipe & hose (B) and then oil level gauge rod (A).
Tightening torque
19.6 ~ 23.5 N.m (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.4 Ib-ft)

   

    Components 1. Engine oil level gauge2. Engine oil level gauge rod

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0304