Hyundai Genesis (DH): Lubrication System / Oil Filter Body Repair procedures

Removal and Installation
Oil filter body
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the engine under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the engine oil filter body (A).

Tightening torque :
20.6 ~ 22.6 N.m (2.1 ~ 2.3 kgf.m, 15.2 ~ 16.1 lb-ft)

   

    Components 1. Oil filter cap2. O-ring3. Oil filter element4. Oil filter body5. Oil seal

    Components 1. 2WD Lower oil pan2. AWD Lower oil pan3. 2WD Upper oil pan4. AWD Upper oil pan5. Cylinder block

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Troubleshooting

    Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. NoProcedure1Park the vehicle on level ground2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic t

    Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Description and Operation

    Description An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the cabin. The signal determined by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signa

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0271