Hyundai Genesis (DH): Seat Electrical / Lumbar support switch Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Seat Electrical / Lumbar support switch Repair procedures

Removal
1.
Disconnect the battery(-) terminals.
2.
Remove the front seat shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover" )

3.
Loosen the screws and remove the electric seat control switch (A).

Installation
1.
Install the Electric seat control switch.
2.
Install the Front Seat Shield Outer cover.
3.
Connect the battery (-) terminals.
Inspection
Air Lumbar Support Switch
1.
Air lumbar support switch sends/receives signals via CAN communication so it is impossible to check the electric current of switch components.
2.
Inspect the air lumbar support system using GDS.
   
Check the air lumbar support system for normal operation by selecting

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: CO2 Sensor Description and Operation

    Description This system maintains the density of carbon dioxide constantly in vehicle interior by measuring the amount of carbon dioxide to increase the comfortableness and the fuel consumption rate when air conditioning system is operating.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Components and Components Location

    Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0201