Hyundai Genesis (DH): Engine Control System / Injector Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Injector Description and Operation

Description
Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by length of injection time. The ECM controls each injector by grounding the control circuit. When the ECM energizes the injector by grounding the control circuit, the circuit voltage should be low (theoretically 0V) and the fuel is injected. When the ECM de-energizes the injector by opening control circuit, the fuel injector is closed and circuit voltage should momentarily reach the peak, and then settle at system voltage.

    Inspection 1. Connect the GDS on the Data Link Connector (DLC ). 2. Measure the output voltage of the FTPS. Specification: Refer to "Specification" Removal 1.

    Specification ItemSpecificationCoil Resistance (?)0.98 ~ 1.14 [20

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Ambient Temperature Sensor Description and Operation

    Description The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharge temperature control, temperature regulation door control,

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0215