Hyundai Genesis (DH): Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures
| Inspection |
| 1. |
Remove the left luggage side trim.
(Refer to Body - "Luggage Side Trim") |
| 2. |
Remove the subwoofer or rear heater.
(Refer to AVN System - "Speakers") |
| 3. |
Remove the fuel filler housing after opening the fuel filler door.
(Refer to Body - "Fuel Filler Door") |
| 4. |
Loosen the two bolts of the fuel filler door release actuator.
|
| 5. |
Remove the fuel filler door release actuator (B) after disconnecting the fuel filler door release actuator connector (A).
|
| 6. |
Check for continuity between terminal No. 1 and No. 2. If
there is no continuity, replace the fuel filler door release actuator
(A).
|
Component Location 1. Fuel filler door open switch2. Fuel filler door release actuator
Inspection 1. Disconnect the battery(-) terminals. 2. Remove the crash pad Lower panel. 3. Disengage the retaining clips and remove the crash pad lower panel switch (A).
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures
Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- General Information
- 4 Wheel Drive (AWD) System
- Brake System
- New on site
- Most important about car
