Hyundai Genesis (DH): Timing System / Front Oil Seal Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures

Removal
1.
Remove the crankshaft pulley.
(Refer to Timing System - "Crankshaft Pulley")
2.
Remove the timing chain cover oil seal (A).

Installation
1.
Using SST (09231-3C100), install timing chain cover oil seal.

   
Always use a new oil seal.
2.
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Pulley")

    Components 1. Front oil seal

    Components 1. Timing chain cover2. Gasket

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: High Mounted Stop Lamp Repair procedures

    Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the high mounted stop lamp assembly (A) after loosening the mounting screws. Installation 1.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation

    Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0214