Hyundai Genesis (DH): Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Inspection
If idle rpm is unstable or engine stops, check the ETC module operation with GDS diagnostic tool.
And if necessary, clean carbon in the throttle body.
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Select "Vehicle S/W management" > "Inspection / Test" > "ETC Performance Test" on the GDS menu.
3.
Perform "ETC module test" procedure in accordance with the message.

4.
If the test result of the ETC module or TPS signal shows NG, perform ETC module cleaning.

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the air intake hose.
(Refer to Engine Mechanical System - "Intake AndExhaust System")
3.
Disconnect the ETC module connector (A).

4.
Disconnect the coolant hose (A).

5.
Remove the ETC module (B) from the engine after loosening the installation bolt (A).

Cleaning
1.
Remove the ETC module.
(Refer to Engine Control System - "ETC Module".)
2.
Keep the opening position of the ETC module plate with the fixing jig.

3.
Clean the contamination part of the throttle body with a soft and lint-free cloth dampened with cleanser to prevent foreign objects from going in.

   

    Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assembly. It senses absolute pressure of the air cleaner assembly and transfers the analog signal proportional to the pressure to the ECM.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Description and Operation

    Description According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's vision from glare, aiming at safety driving. Sensor integrated ECU mounting on the rear center arm drives the actuator mounting on the head lamp since sens

    Hyundai Genesis (DH) 2013-2016 Service Manual: LKAS Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror wiring cover (A) and rain sensor cover (B). 3. Remove the LKAS unit connector (A). 4. Remove the LKAS unit after disengaging the mounting bracket (A). Installation 1.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0362