Hyundai Genesis (DH): Smart Key System / Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Smart Key System / Description and Operation

Description
   
Refer to the "Body Network System" for the abbreviation information.
The SMART KEY system is a system that allows the user to access and operate a vehicle in a very convenient way. To access the vehicle, no traditional key or remote control unit is needed.
The user carries a SMART KEY FOB which does not require any conscious actions by the user (e.g. operate a RKE button). The SMART KEY system is triggered by pressing a push button in the door handle.
After being triggered the vehicle sends out a request in a limited range. If the SMART KEY FOB receives this request, it automatically sends a response to the vehicle. Then the system decides whether to perform a particular action (unlocking, locking

    Component Location (1) 1. Smart key unit2. Buzzer3. Interior antenna 14. Interior antenna 25. Door outside handle Component Location (2) 1. Bumper antenna2.

    Smart Key Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.

    Categories

     
    Copyright © 2025 www.hgenesisdh.com - 0.0277