Hyundai Genesis (DH): Airbag Module / Curtain Airbag (CAB) Module Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Description and Operation
| Description |
Curtain airbags are installed inside the headliner (LH and
RH) and protect the driver and passenger from danger when a side crash
occurs. The SRSCM determines deployment of the curtain airbag by using
the side impact sensor (SIS) signal.
Never attempt to measure the circuit resistance of the airbag
module even if you are using a specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury. |
Removal Front Side Airbag 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat assembly.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
D
Hyundai Genesis (DH) 2013-2016 Service Manual: Intake Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Electrical System
- Starter Repair procedures
- Smart Cruise Control Unit Repair procedures
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0224