Hyundai Genesis (DH): Charging System / Battery Sensor Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures

Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolts (B).

Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation bolt:
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1 lb-ft)
Battery (-) terminal tightening nut:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

    Description Vehicles have many control units that need large amounts of electricity. These units control their own system based on information from diverse sensors.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (B) from the parking assist sensor (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Description and Operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.025