Hyundai Genesis (DH): Engine Control System / Barometric Pressure Sensor (BPS) Specifications
| Specification |
| Pressure (kPa) | Output Voltage (V) |
| 10.0 | 0.50 |
| 55.0 | 2.21 |
| 100.0 | 3.93 |
| 115.0 | 4.50 |
Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assembly. It senses absolute pressure of the air cleaner assembly and transfers the analog signal proportional to the pressure to the ECM.
Circuit Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: High Mounted Stop Lamp Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the high mounted stop lamp assembly (A) after loosening the mounting screws. Installation 1.
Hyundai Genesis (DH) 2013-2016 Service Manual: CO2 Sensor Description and Operation
Description This system maintains the density of carbon dioxide constantly in vehicle interior by measuring the amount of carbon dioxide to increase the comfortableness and the fuel consumption rate when air conditioning system is operating.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Brake System
- 4 Wheel Drive (AWD) System
- Starter Repair procedures
- New on site
- Most important about car
