Hyundai Genesis (DH): Fuel Delivery System / Fuel Pump Control Module (FPCM) Specifications
| Specification |
| ltem | Specification | |
| Supply Voltage (V) | 8~18 | |
| Supply Current (A) | Max. 10 | |
| Fuel Pressure (kpa) | Starting | 600 |
| Drive | 350 ~ 500 | |
| Stop | 20 Under | |
Description The fuel pump control module (FPCM) is installed on the right side of the trunk compartment. It controls the BLDC (Brushless DC) motor mounted inside the variable low pressure fuel pump.
Circuit Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location
Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.
Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Electrical System
- Repair procedures
- Electric Parking Brake (EPB) Repair procedures
- New on site
- Most important about car
