Hyundai Genesis: Front Suspension System / Front Strut Assembly Components and Components Location

Components

[2WD]

1. Insulator cap 2. Insulator assembly 3. Spring upper pad 4. Dust cover

5. Bump stopper 6. Coil spring 7. Spring lower pad 8. Shock absorber

[4WD]

1. Insulator cap 2. Insulator assembly 3. Spring upper pad 4. Dust cover 5. Bump stopper

6. Coil spring 7. Spring lower pad 8. Shock absorber 9. Fork

Components and Components Location

Components Location [2WD] 1. Front shock absorber assembly2. Front stabilizer bar3. Front upper arm4. Front sub frame5. Tension arm6. Lateral arm7. Front knuckle assembly [4WD] 1. Fron ...

Front Strut Assembly Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightening torque: 88.3 ~ 1 ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

Adjustment Introduction It is necessary to check and input the calibration data when the controller is replaced as the characteristics of the internal frictional materials (clutch pack) change due to driving. Creation condition and calibration method 1. In case of replacing the transfe ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Barometric Pressure Sensor (BPS) Description and Operation

Description Barometric Pressure Sensor (BPS) is a speed-density type sensor and is installed on the air cleaner assembly. It senses absolute pressure of the air cleaner assembly and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calculat ...