Hyundai Genesis: Smart High Beam / Turn signals and lane change signals

To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever will return to the OFF position when released or when the turn is completed.

If an indicator stays on and does not flash or if it flashes abnormally, one of the turn signal bulbs may be burned out and will require replacement.

Onetouch turn signal function

To activate an One Touch Turn Signal function, move the turn signal lever slightly and then release it. The lane change signals will blink 3, 5 or 7 times.

You can activate or deactivate the One Touch Turn Signal function or choose the number of blinking (3, 5, or 7) from the User Settings Mode (Light) on the LCD display.

Smart High Beam

The Smart High Beam is a system that automatically adjusts the headlamp range (switches between high beam and low beam) according to the brightness of other vehicles and road conditions. ...

Front fog lamp

Use the switch next to the headlamp switch to turn the Fog Lights ON and OFF. The fog lamps will turn on when the fog lamp switch (1) is turned to the ON position after the headlamps are t ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Input Speed Sensor Repair procedures

Inspection 1. Check signal waveform of Input speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Theft-alarm system

This system helps to protect your vehicle and valuables. The horn will sound and the hazard warning lights will blink continuously if any of the following occurs: - A door is opened without using the smart key. - The trunk is opened without using the smart key. - The engine hood is ...