Hyundai Genesis (DH): Timing System / Front Oil Seal Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures

Removal
1.
Remove the crankshaft pulley.
(Refer to Timing System - "Crankshaft Pulley")
2.
Remove the timing chain cover oil seal (A).

Installation
1.
Using SST (09231-3C100), install timing chain cover oil seal.

   
Always use a new oil seal.
2.
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Pulley")

    Components 1. Front oil seal

    Components 1. Timing chain cover2. Gasket

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0242