Hyundai Genesis (DH): Hydraulic System / Fluid Components and Components Location
| Components Location |
| 1. Oil injection hole 2. Oil level check plug | 3. Oil drain plug |
Components Location 1. Oil seal2. Reaction shaft3. Housing4. Cover5. O-Ring6. Reaction shaft7. Snap ring8. Needle bearing9. 8LR/B return spring10.
Service Adjustment Procedure Oil level Check The ATF level check is not normally required during scheduled services. If an oil leak is found, perform the oil level check procedure after repairs are completed.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Parking Assist Sensor Repair procedures
- Description and Operation
- Emission Control System
- New on site
- Most important about car
