Hyundai Genesis: Engine Control System / ETC (Electronic Throttle Control) System Troubleshooting

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Troubleshooting

Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7°
TPS
TPS 1 fault
ECM looks at TPS2
TPS 2 fault
ECM looks at TPS1
TPS 1,2 fault
Throttle valve stuck at 7°
APS
APS 1 fault
ECM looks at APS 2
APS 2 fault
ECM looks at APS 1
APS 1,2 fault
Engine idle state

   
When throttle value is stuck at 7°, engine speed is limited at below 1,500rpm and vehicle speed at maximum 40 ~ 50 km/h (25 ~ 31 mph)
ETC (Electronic Throttle Control) System Description and Operation
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cab ...

ETC (Electronic Throttle Control) System Specifications
Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V)TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.600.41984.650. ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Front Seat Frame Assembly Repair procedures


Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a p ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Wheel Speed Sensor Repair procedures


Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the rear wheel and tire (A) from the rear hub. Tightening torque : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 3. Remove the wheel speed sensor bracket bolt & wheel speed se ...

© 2013-2024 www.hgenesisdh.com