Hyundai Genesis (DH): Engine And Transaxle Assembly / Engine Room Under Cover Components and Components Location
| Components |
| [2WD] |
| 1. Front under cover 2. Rear under cover | 3. LH side cover 4. RH side cover |
| [AWD] |
| 1. Front under cover 2. Rear under cover | 3. LH side cover 4. RH side cover |
Removal and Installation Engine Cover 1. Remove the engine cover (A).
Removal and Installation 1. Remove the front under cover (A). Remove the rear under cover(B). Tightening torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Repair procedures
Removal Blind Spot Detection Warning Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warning Indicator 1. Install the outside mirror. 2. Connect the negative (-) battery terminal.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Electrical System
- Description and Operation
- Starter Repair procedures
- New on site
- Most important about car
