Hyundai Genesis (DH): Lighting System / Door Mood Lamp Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Lighting System / Door Mood Lamp Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the door mood lamp connectors (A).

4.
Remove the door mood lamp (A) after loosening the screws (3EA).

5.
If it is necessary to replace the bulb, replace the bulb (A) after disconnecting the connector.

Installation
1.
Install the door mood lamp and connector.
2.
Install the front door trim.
3.
Connect the negative (-) battery terminal.

    Inspection 1. Remove the overhead console lamp assembly and check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

    Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. No.Description1BAT (+)2Illumination (+)3-4Signal5Pilot lamp6-7Illumination (-)8GND Removal    

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Components and Components Location

    C

    Hyundai Genesis (DH) 2013-2016 Service Manual: Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) or cool (Passenger's side) position when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0253