Hyundai Genesis: Blower / Climate Control Air Filter Repair procedures

Replacement

1.	Remove both stoppers (B) by turning them from the glove box (A).

2.	Disconnect the air damper (A) from the glove box (B).

3.	Remove the filter cover (A) by pressing the knob.

4.	Replace the air filter (A) with a new one according to the direction of air filter. • To remove the filter easily, press the right side inward and pull out the filter. • In case of driving in an air-polluted area or rugged terrain, check and replace the air filter as frequently as possible.

5.	Install in the reverse order of removal.

Climate Control Air Filter Description and Operation

Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventio ...

Intake Actuator Description and Operation

Description The intake actuator is located in the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch (indoor or ambient) will shif ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures

Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover. (Refer to Engine Mechanical System - " ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rail Pressure Sensor (RPS) Description and Operation

Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control co ...