Hyundai Genesis (DH): Blower / Intake Actuator Description and Operation

Description
The intake actuator is located in the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch (indoor or ambient) will shift to.

    Replacement 1. Remove both stoppers (B) by turning them from the glove box (A). 2. Disconnect the air damper (A) from the glove box (B). 3.

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Components and Components Location

    Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0289