Hyundai Genesis (DH): AWD Control System / AWD ECU Schematic Diagrams

Hyundai Genesis (DH) 2013-2016 Service Manual / 4 Wheel Drive (AWD) System / AWD Control System / AWD ECU Schematic Diagrams

Circuit diagram
AWD ECU connector

AWD ECU terminal function
1
Motor electric power
2
Ground connection
3
Ignition
4
-
5
-
6
CAN high
7
CAN low
8
Electric power supply controller

    AWD ECU input/output diagram

    Removal 1. IG Key "ON". 2. Connect the GDS in the vehicle. 3. To read the transfer case data in old ITA(ECU), select "ECU Data Back-up & Writing" service of GDS.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, replace it with a genuine blower motor check for proper operation. 3. Replace the blower motor if it is proved that there is a problem with it.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0239