Hyundai Genesis (DH): Automatic Transmission Control System / 27 Brake Control Solenoid Valve Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 27 Brake Control Solenoid Valve Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between solenoid valve terminals.
4.
Check that the resistance is within the specification.

    Circuit Diagram

    Description UD Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the UD Clutch.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Start/Stop Button Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the start/stop button (A) from the center fascia garnish after loosening the mounting clip.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0236