Hyundai Genesis: Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the VIS valve connector.

3.	Measure resistance between the VIS valve terminals 1 and 2.

4.	Check that the resistance is within the specification. Specification: Refer to “Specification”

Removal

[VIS #1]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the variable intake solenoid valve connector (A).

3.	Disconnect the vacuum hoses (B) from the valve.

4.	Remove the installation nut (C) and then remove the valve from the surge tank.

[VIS #2]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the variable intake solenoid valve connector (A).

3.	Disconnect the vacuum hoses (B) from the valve.

4.	Remove the installation nut (C) and then remove the valve from the surge tank.

Installation

• Install the component with the specified torques. • Note that internal damage may occur if the component drops. In this case, inspect it before installation.

• Be careful of foreign materials not to flow into the valve.

1.	To install, reverse the removal procedure. Variable intake solenoid valve installation nut: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Variable Intake Solenoid (VIS) Valve Schematic Diagrams

Circuit Diagram ...

Fuel Pressure Control Valve Description and Operation

Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls the fuel amount flowing into the injectors in accordance with the ECM signal calculated based ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rain Sensor Repair procedures

Removal     The dust or foreign substance on the rain sensor has a bad effect upon the rain sensor capability, so protect the sensor surface with protection cover until installing the rain sensor to bracket for accurate function The coupling pad on the rain sensor surface ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

Component Location 1. Head lamp (Low/)2. Head lamp (High)3. Head lamp (BI-FUNCTION)4.Turn signal lamp5. Side marker lamp6. Position lamp (USA only) Position lamp & DRL7. Vanity lamp8. Turn signal lamp (Door mirror)9. Fog lamp10. Room lamp (NON-Panorama Sunroof)11. Personal lamp (Panorama Su ...