Hyundai Genesis: Trunk Lid / Trunk Lid Key Holder Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface.

1.	Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")

2.	Loosen the trunk lid key holder mounting bolts.

3.	Remove the trunk lid key holder (B) and disconnect the trunk lid key holder cable (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.	Install in the reverse order of removal. • Make sure the trunk lid locks/unlocks and opens/closes properly. • Replace any damaged clips.

Trunk Lid Trim Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Trunk Lid Back Panel Components and Components Location

Component Location 1. Trunk lid back panel 2. Tailgate garnish ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Injector Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal     ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Lower Arm Repair procedures

Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the rear hub. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     Be careful not to damage the ...