Hyundai Genesis: Trunk Lid / Trunk Lid Back Panel Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface.

1.	Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")

2.	Remove the inside rear combination lamp. (Refer to Body Electrical System - "Rear combination lamp")

3.	Loosen the mounting nut, and remove the trunk lid panel (A).

4.	Remove the tailgate garnish (B).

5.	Install in the reverse order of removal. • Make sure the connector are connected in properly. • Replace any damaged clips.

Trunk Lid Back Panel Components and Components Location

Component Location 1. Trunk lid back panel 2. Tailgate garnish ...

Trunk Lid Weatherstrip Repair procedures

Replacement 1. Remove the trunk lid weatherstrip (A).     • Do not apply sealant to the body. 2. Install in the reverse order of removal.     â ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: CVVT (Continuously Variable Valve Timing) System Description and Operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which m ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Front Differential Assembly(AWD) Components and Components Location

Components Location 1. Front propeller shaft2. Transfer case3.Front differential assembly Components 1. Pinion lock nut 2. Companion flange 3. Pinion oil seal 4. Pinion front bearing 5. Pinion front bearing race6. Pinion cage7. Pinion rear bearing race8. Inner bearing gear adjustment shim ...