Hyundai Genesis: Indicators And Gauges / Troubleshooting

Troubleshooting
Error Item
Failure symptom
Inspection items
Detailed inspections
Relevant Parts/
Components
Screen display
TFT-LCD screen does not turn on
1.
Connector attachments
2.
Components
1.
Check the connector attachments
2.
Check B+, IGN and GND wiring
3.
Check the components
Connectors, wiring, fuses, dashboard
Warning light
Airbag warning lamp malfunction
1.
Connector attachments
2.
C-CAN
3.
Components
1.
Check airbag + signal (connectors)
2.
Check C-CAN (ACU4) signal
3.
Check the FPC attachment inside the dashboard
ACU Connectors, wiring, fuses, dashboard
Mode conversion
Integrated driving mode malfunction
1.
Connector attachments
2.
Switch
3.
Components
1.
Check the switch input (connector)
2.
Check the switch signal input
(disconnection or shorting)
3.
Check conversion with dashboard component
Switch connector, wiring dashboard
Illumination
Interior light brightness cannot be controlled.
1.
Connector attachments
2.
Switch
3.
Components
1.
Check if the light switch's input signal reaches the connector
2.
Check ILL- and DETENT signals
3.
Check the TAIL+ signal input
Switch connector, wiring dashboard
Warning Sound
No dashboard alarm
1.
Connector attachments
2.
Car speakers
3.
Components
1.
Check the speaker output connector
2.
Check the car speakers
Speaker connectors, wiring dashboard
Fuel indicator
Faulty fuel gauge indication
1.
Connector attachments
2.
Fuel sender
3.
Components
1.
Check fuel input and GND connectors
(open, short or input resistance values)
2.
Check fuel sender
Fuel sender connector, wiring dashboard

Instrument Cluster Repair procedures
Removal     Special care is needed for the following points in case of working with the non-gloss timber trimming. • Apply the protective tape to the tool when disassem ...

Power Door Locks
...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Repair procedures


Removal Blind Spot Detection Warning Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warning Indicator 1. Install the outside mirror. 2. Connect the negative (-) battery terminal. Inspection Diagnosis With ...

Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing. 3. Connector the negati ...

© 2013-2025 www.hgenesisdh.com