Hyundai Genesis: Automatic climate control system / System operation

Ventilation

1. Set the mode to the position.

2. Set the air intake control to the outside (fresh) air position.

3. Set the temperature control to the desired position.

4. Set the fan speed control to the desired speed.

Heating

1. Set the mode to the position.

2. Set the air intake control to the outside (fresh) air position.

3. Set the temperature control to the desired position.

4. Set the fan speed control to the desired speed.

5. If dehumidified heating is desired, turn the air conditioning system on.

• If the windshield fogs up, set the mode to the or press the front defrost button .

Operation Tips

  • To keep dust or unpleasant fumes from entering the car through the ventilation system, temporarily set the air intake control to the recirculated air position. Be sure to return the control to the fresh air position when the irritation has passed to keep fresh air in the vehicle. This will help keep the driver alert and comfortable.
  • Air for the heating/cooling system is drawn in through the grilles just ahead of the windshield. Care should be taken that these are not blocked by leaves, snow, ice or other obstructions.
  • To prevent interior fog on the windshield, set the air intake control to the fresh air position and fan speed to the desired position, turn on the air conditioning system, and adjust the temperature control to desired temperature.
Climate information screen selection button
To change the screen into the climate information screen, press the climate information screen selection button. ...

Air conditioning
1. Start the engine. Push the air conditioning button. 2. Set the mode to the position. 3. Set the air intake control to the outside air or recirculated air position. 4. Adjust the fan speed c ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Pump Control Module (FPCM) Repair procedures


Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. If there is DTC on the GDS, replace the FPCM. 3. Check the output voltage of fuel pressure sensor (FPS). Specification: 5V 4. Check the output voltage of fuel pressure sensor (FPS) at idle. Specification: 1.4 ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Filler-Neck Assembly Repair procedures


Removal 1. Remove the filler neck mounting screws (A) after opening the fuel filler door. 2. Remove the rear-left wheel & tire and wheel house cover. 3. Disconnect the fuel filler hose (A) and leveling hose (B). 4. Disconnect the vent hose quick-connector (C). 5. Remove the ...

© 2013-2022 www.hgenesisdh.com