Hyundai Genesis: AVN System / Steering Wheel Remote Controller (SWRC) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / AVN System / Steering Wheel Remote Controller (SWRC) Repair procedures

Inspection
   
Steering Wheel Remote Control system (SWRC) can be diagnosed by GDS because it receives and sends signals through CAN communication.
1.
Check for resistance between terminals in each switch position(LH).

[Audio]
Switch
Connector
terminal
Resistance
(±5%)
Speech Recognition
6~8
18.81k?
SEEK UP
6~8
4.51k?
SEEK DN
6~8
2.11k?
Mode
6~8
6.71k?
SEND
6~8
430?
END
6~8
1.11k?
MUTE
1~8
0
VOL UP
2~3
-
VOL DN
2~3
-

2.
Check for resistance between terminals in each switch position(RH).

[Cruise]
Switch
Connector
terminal
Resistance
(±5%)
CANCEL
2~3
180?
RES+
2~3
550?
SET-
2~3
330?
Cruise ON/OFF
2~3
880?
Space betweencars
2~3
2.54k?

Diagnosis With GDS
1.
In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (GDS).
The diagnostic system(GDS) provides the following information.
(1)
Self diagnosis : Checking failure and code number (DTC)
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Controlling other features including system option setting and zero point adjustment
2.
Select the 'Car model' and the steering wheel remote control system (SWRC) to be checked in order to check the vehicle with the tester.
3.
Select the 'Current Data' menu to search the current state of the input/output data.

4.
To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove the screws from the steering cover.

4.
Remove the steering back cover(A).

5.
Remove the steering remote control connector(A).

6.
Loosen the screws and remove the steering remote control (A).

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Install the cover and driver airbag module.
3.
Connect the negative (-) battery terminal.
Steering Wheel Remote Controller (SWRC) Description and Operation
Description The steering wheel remote controller (SWR) is composed of four switches and the right top switch is equipped with the Body CAN communication module. The left bottom remote control ...

AVN Antenna Components and Components Location
Components ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box") 3. Disconnect the body control module connectors (A). 4. Remove the mounting nuts(2) to loosen the BCM (A). Installation 1. Install the body control module. ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures


Removal     • Put on gloves to prevent hand injuries.     • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side molding. (Refer to Body Side Moldings - "Roof Side Molding") 2. Remove the rear package tray trim. ( ...

© 2013-2025 www.hgenesisdh.com