Hyundai Genesis: Seat Electrical / Seat heater Repair procedures

Inspection
Front Seat Heater
1.
Check for continuity and measure the resistance between terminals.


Standard value (Fabric / Leather)
Driver / Assists (cushion + back): 1.63?±10%

2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value (Fabric / Leather)
1st : cushion : 36±2°C, back : 40±2°C
2st : cushion : 39±2°C, back : 45±2°C
3st : cushion : 42±2°C, back : 50±2°C

Rear Seat Heater
1.
Check for continuity and measure the resistance between terminals.


Standard value (Fabric / Leather)
Rear seat(cushion + back): 2.18?±10%

2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value (Fabric / Leather)
1st : cushion : 36±2°C, back : 40±2°C
2st : cushion : 39±2°C, back : 45±2°C
3st : cushion : 42±2°C, back : 50±2°C

Seat heater Schematic Diagrams
Circuit Diagram ...

Seat heater switch Components and Components Location
Components ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Accelerator Position Sensor (APS) Description and Operation


Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power ...

Hyundai Genesis (DH) 2013-2016 Owners Manual: Auto defogging system ON/OFF


If your vehicle is equipped with the auto defogging system, it is automatically activated when the conditions are met. However, if you would like to cancel the auto defogging system, turn off the Auto defogging function in the AVN climate monitor. If the battery has been disconnected ...

© 2013-2025 www.hgenesisdh.com