Hyundai Genesis: Rear Door / Rear Door Inside Handle Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door side curtain.
(Refer to Body Electrical System - "Rear door side curtain")
3.
Disconnect the rear door inside handle lamp connector (A).
4.
After loosening the mounting screws, remove the rear door inside handle (B).

5.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Make sure the door locks/unlocks and opens/closes properly.
Replace any damaged clips.
Rear Door Trim Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • Be careful not to scratch or dent the crash pad garnish and door trim upper garn ...

Rear Door Window Glass Components and Components Location
Component Location 1. Rear door window glass ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Tank Pressure Sensor (FTPS) Repair procedures


Inspection 1. Connect the GDS on the Data Link Connector (DLC ). 2. Measure the output voltage of the FTPS. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Fold the rear seat cus ...

Hyundai Genesis (DH) 2013-2016 Service Manual: License Lamps Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Back Panel") 3. Remove the license lamp after disengaging the license lamp mounting clip (A) 4. Remove the license lamp assembly after disconnecting the license connec ...

© 2013-2021 www.hgenesisdh.com