Hyundai Genesis: Body Side Molding / Roof Side Molding Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the roof side molding (A).
   
Be sure to replace the roof side molding with a new one.

2.
Install in the reverse order of removal.
   
Replace any damaged clips.
Body Side Molding
...

Front Wheel Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: ECS Control Unit Repair procedures


Replacement 1. Disconnect the battery (-) terminal. 2. Remove the trunk luggage side trim [RH]. (Refer to Body - "Trunk Trim") 3. Disconnect the connector and then remove the ECS control unit. Installation 1. Installation in the reverse order of removal. 2. Perform the ESC var ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Power Mosfet Repair procedures


Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and control the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)13.4 ± 0.5 (A/C OFF)3.8 ± 0.5 (A/C ON)24 ...

© 2013-2023 www.hgenesisdh.com